Stollen

Description

Attention: these cleats fit sizes 3-11 (not for smaller sizes)

1 piece of studs for scoot boots (2 studs are recommended in the traditional costume area, or 2 studs and 2 studs per shoe)

Simple installation of the cleats as follows:

1. Pre-drill with a 4.5mm drill bit
2. re-drill from both sides with an 8 mm drill bit to deburr/clean the drill hole
3. hammer in the stud with a hammer
4. tighten the nut by hand and then tighten with an open-end wrench
5. Make sure that the screw head is flush with the inside of the sole and does not protrude